Tuesday, June 21, 2016

Top 6 Tips For Car Dent Repairing

There are a variety of ways to remove a dent from your car. However, first you need to closely analyze the dent before you either use paint less dent repair or typical repair. After you have decided what technique you are going to utilize for the dent the automobile must be made ready before removing it. A variety of steps you would like to follow before getting rid of a dent in the best manner.


Here are some of the top tips that will help you to remove all types of car dent easily.

Tip #1: Wash The Automobile

The first step you must do is to scrub the automobile. However, ensure to use dish laundry soap instead of using regular automobile soap. The explanation for this can be the very fact that the majority automobile soaps out there leave behind some wax and silicone which makes dent removal tough. The concept is to remove all that wax off so no matter which technique you utilize your tools & equipment doesn't slip.

Tip #2: Get Rid Of All Grease And Wax

By using a common grease remover, wax and grease should be completely removed from the spot. There are various grease removers you'll be able to use. As an alternative some lemon juice and hot water can also assist to get rid of grease.

Tip #3: Finding The Correct Tools & Equipment

Before you'll be able to repair a dent you may get to collect the right tools. If either side of the dent is accessible, then you'll be able to use a dolly and hammer. If you're able to solely access one side then use a stud welding gun which can be bought from most of the hardware stores.

Tip #4: The Best Rule Of Removing Car Dent

Use the first to the last rule. This suggests that you need to start from repairing the first dent and then work your way to the last dent. Thus primarily you would follow the same sequence in which your automobile took dents.

Tip #5: Heat Shrinking

Heat shrinking is employed to mainly shrink the metal a bit. You'll be able to shrink any metal by employing a few ice cubes with a shrinking hammer. In some cases you may got to use the heat technique that expands the metal by employing a torch and shrinking it quickly utilizing ice to remove tiny dents. Remember, applying the blow torch for extended time periods than required might harm the paint and the metal.

Tip #6: Filler

After straightening the metal use some body filler. Body filler should be applied to the steel or metal directly, and then the old coating is removed.

See Also : 6 easy steps to complete wheel repair

0 comments

Post a Comment